199
Connecting External Devices
By connecting the RM-700 to your audio equipment or external
speakers, you can play the RM-700’s sounds from your stereo
system’s speakers or from other external speakers, or record your
performance on a recording device.
• If you use a connection cable that has a built-in resistor, the volume
of the device connected to the input jack may be low. Please use
connection cables that do not contain a resistor.
• To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power on all
devices before making any connections.
1.
Minimize the volume of the RM-700 and of the speakers
you are connecting.
2.
Switch off power to the RM-700 and the speakers you are
connecting.
3.
Make connections using separately available audio
cables.
4.
Switch on the RM-700’s power.
5.
Switch on power to the connected speakers.
6.
Adjust the volume of the RM-700 and the connected
speakers.
Play the RM-700’s keyboard, and sound will be produced from the
connected speakers (or stereo set).
Turning the Power Off
1.
Minimize the volume of the RM-700 and of the connected
speakers.
2.
Switch off power to your speakers.
3.
Switch off power to the RM-700.
1.
Minimize the volume of the RM-700 and of the audio
device you are connecting.
2.
Switch off power to the RM-700 and the audio device you
are connecting.
3.
Make connections using commercially available audio
cables.
4.
Switch on power to the audio device.
5.
Switch on the RM-700’s power.
6.
Adjust the volume of the RM-700 and the connected
audio device.
Turning the Power Off
1.
Minimize the volume of the RM-700 and of the connected
audio device.
2.
Switch off power to the RM-700.
3.
Switch off power to the connected audio device.
Connecting Audio Equipment
Playing the RM-700 through Connected
Speakers
INPUT (LINE IN)
Speaker etc.
Audio cable
Playing the Sound of an Audio Device
through the RM-700
Audio cable
Stereo System
OUTPUT
(LINE OUT)
RM-700_e.book 199 ページ ２００９年３月１８日 水曜日 午前１１時５分
To Next Page
