206
Error Messages
* External Media: USB memory, CD-ROM, etc.
Indication
Meaning
Error: 1
You can only read the music file. It can not be saved.
Error: 2
An error occurred during writing.
The external media’s protect tab may be in the “Protect” (writing prohibited) position, or the external media
may not yet be initialized.
Error: 3
This CD is not writable.
Insert a writable CD and try the operation again.
Error: 4
An error occurred while writing to the CD.
Check the connection with the CD drive, and try the operation again.
Error: 5
An error occurred while writing to the CD.
The CD may have been damaged. Insert a different writable CD and try the operation again.
Error: 6
Not enough free space on the CD.
Insert a different writable CD and try the operation again.
Error: 7
An error occurred while finalizing the CD.
Check the connection of the CD drive, and try the operation again.
Error: 10
No external media is inserted. Insert the external media and try again.
Error: 11
There is not sufficient free memory in the save destination.
Either insert other external media or delete unneeded files and try again.
Error: 14
An error occurred during writing. The external media may be corrupted.
Insert other external media and try again. Alternatively, you can initialize the external media.
Error: 15
The file is unreadable. The data format is not compatible with the RM-700.
Error: 16
Data was not called up in time for playback of the song.
After waiting several seconds, you may be able to play back the song by pressing the [ (Play/Stop)]
button again.
Error: 17
The selected image data cannot be displayed.
Prepare image data that can be used with the RM-700 (p. 92).
Error: 18
The song is in an unsupported audio/MP3 format.
Use a song in an audio/MP3 format that the RM-700 supports.
For details on audio/MP3 formats, refer to p. 205.
Error: 30
The internal memory capacity of the RM-700 is full.
Error: 40
The RM-700 cannot deal with the excessive MIDI data sent from the external MIDI device. Reduce the amount
of MIDI data sent to the RM-700.
Error: 41
A MIDI cable has been disconnected. Connect it properly and securely.
Error: 43
A MIDI transmission error has occurred. Check the MIDI cable and connected MIDI device.
Error: 51
There may be a problem with the system. Repeat the procedure from the beginning.
If it is not solved after you have tried several times, contact the Roland service center.
Error: 65
The External Memory port was subjected to excessive current. Make sure that there is no problem with the
external media, then turn the power off, then on again.
RM-700_e.book 206 ページ ２００９年３月１８日 水曜日 午前１１時５分
To Next Page
Loading...
