Sam4s ER-5200 - Program 300 - PLU Descriptor Programming

100 • Program Mode Programming ER-5200/40/15
Program 300 - PLU Descriptor Programming
Program descriptors by typing descriptors on the alpha keyboard overlay or by entering three
digit alpha character codes. To enter descriptions using alpha character codes you must
select ‘N’ in system option #25(See “System Option Programming).
1. Turn the control lock to the P position
2. To begin the program, enter 3 0 0, press the SBTL key.
0 SBTL03
3. Select the PLU you wish to program in one of the following ways:
• Press a PLU key on the keyboard, or
PLU
•
Enter up to 15 digit number of the PLU and press the PLU key, or
PLU
Enter the
PLU#
,
up to 15 digits
4. If you are programming a description using the alpha overlay,
Type up to 18
descriptor keys
X/TIME
or,
X/TIME
Enter up to 18
three-character
codes
5. To program additional PLUs, repeat from step 3, or press the CASH key to
finalise the program.
CASH