104 • Program Mode Programming ER-5200/40/15
System Option Programming
Refer to the “System Option Table” to review the system options. Read each option carefully to determine if you wish to
make any changes.
NOTE: Because after clearing memory all option settings are automatically set to 0, and
because your most likely option selections require a status setting of 0, you do not need to
program this section unless you wish to change the default status.
Programming a System Option:
1. Turn the control lock to the P position.
2. Enter 3 0, press the SBTL key.
3. Enter a system option address, press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more
than one decision to be made in an address, add the values representing your
choices for each decision and enter the sum. Press the SBTL key.
5. Repeat from step 3 for each system option that you wish to change.
6. Press the CASH key to end system option programming.
System Option Flowchart
SBTL
To Next Page
Loading...
