Sam4s ER-5200 - Training Mode Password

178 • Program Mode Programming ER-5200/40/15
Training Mode Password
If you wish to use training mode, you must program a password that you will use to enter
training mode. The password may be up to 4 digits long, however, if you choose to use a
password less that for digits, you must enter preceeding zeros to complete a 4 digit entry. For
example, if you program the password to be "77", you must type "0077" when entering training
Programming the Check Change Limit
1. Turn the control lock to the P position.
2. To begin the program, enter 18 0 0, press the SBTL key.
0 SBTL
0 8 1
3. Enter a 4-digit password and press the X/TIME key.
X/TIME
Enter the Password
up to 4 digits
4. Press the CASH key to finalise the program.
CASH