Sam4s ER-5200 - Cash-In-Drawer Limit Programming

174 • Program Mode Programming ER-5200/40/15
Cash-In-Drawer Limit Programming.
A Cash-In-Drawer limit can be programmed so that a warning appears on screen when the
limit is exceeded. Pressing the CLEAR key will remove the error. The operator should carry
out a Paid Out operation to reduce the Cash-in-drawer amount.
Programming the Drawer Limit
1. Turn the control lock to the P position.
2. To begin the program, enter 1 1 0 0, press the SBTL key.
0 SBTL
0 1 1
3. Enter a cash-in-drawer limit (up to 8 digits or 0 for no limit); press the X/TIME
key.
X/TIME
Enter the cash
limit, up to 8
digits
4. Press the CASH key to finalise the program.
CASH