Sam4s ER-5200 - Clerk Sign-On;Sign-Off; Direct Sign-On; Coded Sign-On

ER-5200/40/15 Operating Instructions • 23
Clerk Sign-On/Sign-Off
See "System Option Programming”, to review your clerk options:
• System option #2 allows you to select direct or code entry sign on and/or stay-
down or pop-up operation.
Depending on how your machine has been programmed, sign-on will take place only at the
beginning of a shift (stay-down), or may have to be repeated for each transaction (pop-up). If
your machine has been programmed for stay-down clerks, the clerk currently signed on must
be signed off before another clerk may be signed on.
Direct Sign-On
There are two ways to sign on a clerk. One is to enter the clerk number and press
the clerk key and the other is to enter direct clerk no. key.
CLERK
Clerk # (1
-
1
5
)
CLERK 1 ~ CLERK 10
There are two ways to sign the clerk off. One is to enter 0 (Zero) and press the clerk key and
the other is to enter 0 (zero) and press direct clerk no. key.
0 CLERK
CLERK 1 ~ CLERK 10
0
Coded Sign-On
To sign on a clerk, press the clerk key, enter the clerk code, then press the clerk key again.
CLERK
CLERK
Clerk Code (up to 6 digits)
To sign the clerk off, enter 0 (Zero) and press the clerk key.
0 CLERK