ER-5200/40/15 Program Mode Programming • 85
Program Mode Programming
Default Programming
• All keyboard PLUs are non-taxable and open, without entry limits by default
status programming of "00000000".
• All system options are set to 0 in default programming, unless otherwise noted.
Change only the options, which will deviate, from default programming. There is
no need to re-enter an option status of 0, since 0 is its original setting.
• All programming (unless otherwise stated) is done with the control lock in the P
position. Each section details a specific area of register programming.
Descriptor Programming Methods
Descriptors are programmable for PLUs, function keys, groups, clerks and the logo/messages.
There are two methods available to program descriptors, the Program Overlay Method and
the Descriptor Code Method.
This chapter describes both methods. ER5200/40 use overlay method by default and ER5215
use descriptor code method by default. You can select each method by System option
programming.
To Next Page
Loading...
