Sam4s ER-5200 - Training Mode

ER-5200/40/15 Operating Instructions • 25
Training Mode
A training mode is available so that you can operate the cash register without updating totals
and counters. Note the following conditions:
• The receipt and journal print the message "TRAINING MODE BEGIN" when
training mode is activated.
• The receipt and journal print the message "TRAINING MODE END" when
training mode is exited.
• The message "TRAINING MODE" prints on each receipt printed while training
mode is active.
•
The journal does not print during training mode.
To Enter Training Mode
There are two ways to enter the train mode. One is by training password and the other is
by training clerk. First, you must program a training password
1. Turn the control lock to the X position.
2. To begin the program, enter 199, press the SBTL key.
9 SBTL
9 1
3. Input Training Password # and press X/TIME key.
PASSWORD # X/TIME
To Exit Training Mode
1. Turn the control lock to the X position.
2. To begin the program, enter 199, press the SBTL key.
9 SBTL
9 1
3. Input Training Password (Zero is the default code) and press X/TIME key.
0 X/TIME