Sam4s ER-5200 - Program 400 - PLU Delete Programming

102 • Program Mode Programming ER-5200/40/15
Program 400 – PLU Delete Programming
NOTE: To delete a PLU, all totals for the PLU must be cleared from Z reports(including
Stock and PLU reports.)
1. Turn the control lock to the P position.
2. To begin the program, enter 4 0 0, press the SBTL key.
0 SBTL
0 4
3. Select the PLU or PLUs you wish to program in one of the following ways:
• Press a PLU key on the keyboard, or
PLU
• Press the first PLU key to be deleted, then press the last PLU key to be
deleted, or
PLU PLU
• Enter up to 15 digit number of the PLU and press the PLU key, or
PLU
Enter the PLU#,
up to 15 digits
• Enter the number of the first PLU in a range to be deleted and press the
PLU key, then enter the last number in the range, and press the PLU key.
PLU
Enter the PLU#,
up to 15 digits
Enter the PLU#,
up to 15 digits
PLU
4. Press X/TIME key.
X/TIME
5. To program additional PLUs, repeat from step 3, or press the
CASH
key to
finalise the program.
CASH