Sam4s ER-5200 - Memory Management

74 • Service Mode Programming ER-5200/40/15
Ram Clear & Memory Allocation
1. Turn the key to S mode, whilst powering on the register hold down the
CHEQUE key. Then press the top left, bottom left, top right and bottom
right keys to start the memory allocation procedure
If you want to allocate memory by default value, Press CASH key only,
Alternatively.
Refer to the chart below . Enter the index number and press the X/TIME key.
X X/TIME
X MEMORY ITEM
1
PLU
2
CLERK
3
GROUP
4
CHECK#
5
SOFT CHECK LINE
6
CHECK TYPE : Hard(1), Soft(0)
7
PRICE LEVEL
8
MIX AND MATCH
2. Enter the Number to allocate for the Memory Item and Press CASH key.
See the example data table below
N
CASH
MEMORY ITEM N
PLU
1000 (Max.10000)
CLERK
15 (Max. 99)
GROUP
20 (Max. 99)
CHECK #
20 (Max. 500)
SOFT CHECK LINE
50 (Max. 100)
CHECK TYPE
0(Soft Check), 1(Hard Check)
PRICE LEVEL
1 (Max. 2)
MIX AND MATCH
20 (Max. 99)
Default Memory Allocation
3. If you want to finish memory allocation, Enter CASH key with no numeric key
input. And if you want to allocate another memory area, Repeat the file number
entry sequence