Santec SNC-3302 - Auto Pan

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 147 -
2.7.4 Auto pan
The auto pan setting can be found under this path: PTZ > Auto Pan
Auto pan setting:
• Select an auto pan path (=auto pan number) from the drop-down list. Overall, 4 auto
pans can be defined.
• Left-click into the live picture.
The cursor turns into a red arrow/dot. You can now move the picture to the desired
position.
• If required, you can adjust the picture by clicking on the zoom and focus buttons.
• Click on „Start point: Set“ to start the cruise.
• Click on „End point: Set“ to end the cruise.
• Enter the auto pan speed from 0 to 3: 0 = slow; 3 = fast.
• Enter the auto pan direction: left or right.
Auto pan run list:
To run a specific auto pan, select the desired auto pan path (= auto pan number) from the
drop-down list.
To display the auto pan as full screen, right-click in the live picture and select “Fullscreen”. By
double-clicking in the full screen picture, you return to the regular view.