Santec SNC-3302 - Appendix: Install Upnp Components

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 157 -
Appendix: Install UPnP components
For Windows XP:
Please proceed as follows to install UPnP for Windows XP:
1. Go to <Start>, then click on <Control Panel> and double-click on <Add or Remove
Programs>.
2. Click on <Software>.
3. Click on <Add/Remove Windows Components>.
4. In the Windows wizard window, click on <Networking Services>> and then on
<Details>.
5. Select <UPnP user interface> and confirm with <OK>.
6. Click on <Next>.
7. Click on <Finish> to complete the installation.
For Windows Vista and Windows 7:
Please proceed as follows to install UPnP for Windows Vista and Windows 7:
By default, the windows firewall blocks network discovery (formally called UPnP technology),
but you can enable it in the following way:
1. Click on <Start> and then click on <Control Panel>.
2. Click on <Network and Internet> and then on <Network and sharing center>.
3. If the network discovery (UPnP) is off, click on the arrow icon
to expand the
section.
4. Click on <Turn on network discovery> and then on <Apply>. If prompted for an
administration password or a confirmation, please type the password or provide the
confirmation.