Santec SNC-3302 - Appendix B: Flange Back Adjustment (Only for SNC-3302, SNC-3303 and SNC-3305)

User manual
SANTEC IP cameras
_________________________________________________________________________________
- 78 -
Appendix B: Flange back adjustment
Only for SNC-3302, SNC-3303 and SNC-3305
Note:
The lens is not included in the camera delivery. Please see the SANTEC webshop
www.santec-video.com
for recommended lenses.
Manual flange back adjustment should only be made if the used lens doesn’t achieve a focus
on its own.
Loosen the little lock screw using the Allen wrench (which is included in this delivery).
Now carefully turn the ring left or right to adjust the flange back. Fasten the little lock screw
again.
Lock screw for flange
back adjustment
Ring for flange
back adjustment