Satec BFM 136 - Page 28

Chapter 3 BFM136 Graphical Display Operations Navigation Buttons
Branch Feeder Monitor 136_Installation Operation and Manual 28
Total Energy and Maximum Demand Registers
Page No
Page content
Description
1
Total kWh:
124100.0
Total kWh
2
Total kvarh:
124.0
Total kvarh
2
Total kVA:
124100.0
Total kVAh
3
Max.Dmd kW
25.588
Total kW maximum demand
4
Max.Dmd kvar
4.709
Total kvar maximum demand
5
Max.Dmd kVA
26.017
Total kVA maximum demand
6
Max.Dmd I1, A
15.58
Ampere maximum demand
7
Max.Dmd I2, A
15.58
Ampere maximum demand
8
Max.Dmd I3, A
15.58
Ampere maximum demand
9
Max.Dmd V1, V
120.5
Volt maximum demand
10
Max.Dmd V2, V
120.5
Volt maximum demand
11
Max.Dmd V3, V
120.5
Volt maximum demand
Service Display
Page No
Page content
Description
1
Diagnostics
3
Device diagnostics. See Diagnostics Display below.
2
S/N 956456
Device serial number
3
S/W V18.5.1
Boot: V1.2.1
Software version
Boot loader version
4
COM1:
A1, Bd19.2
COM1 port: address and baud rate
5
COM2: Ethernet
192.168.0.203
COM2 port: node address and net ID, or IP address
6
Ph1 Ph2 Ph3
I1 I2 I3
Submeter phase current assignments
Diagnostics Display
The diagnostics display shows a list of the device diagnostic codes recorded as a result of the meter self-
test diagnostics. The diagnostics page is only displayed if errors were detected.
See Device Diagnostic Codes in Appendix F for the list of diagnostic codes and their meanings. See
Device Diagnostics in Chapter 2 for more information on the BFM136 built-in diagnostics. See Reset in
Chapter 3 on how to clear the device diagnostics status from the display.
ENTER