Satel Versa - Page 28

26 User Manual SATEL
10. Step 5e. Assigning function to 433 MHz keyfob button 3. Proceed in the same way as
in Step 5c, and then press the key.
11. Step 5f. Assigning function to 433 MHz keyfob button 4. Proceed in the same way as
in Step 5c, and then press the key.
12. Step 5g. Assigning function to 433 MHz keyfob button 5 (two buttons are pressed
simultaneously: 1 and 2). Proceed in the same way as in Step 5c, and then press the
key.
13. Step 5h. Assigning function to 433 MHz keyfob button 6 (if there is no button 6 in the
keyfob, two buttons are pressed simultaneously: 1 and 3). Proceed in the same way as in
Step 5c, and then press the key.
Note: Pressing the key between Step 5a and Step 5h will cancel the keyfob adding,
but will not terminate the user adding procedure.
14. Step 6. Adding APT-100 keyfob. If the ABAX wireless system controller (ACU-100 or
ACU-250) is connected to the control panel, the bidirectional APT-100 keyfob can be
assigned to the user. To add a keyfob, press in turn the and keys (if the
keyfob is not to be added, press the key only, or any key with a number from 2 to 9,
and then press key).
15. Step 6a. Selecting APT-100 keyfob addition method. Press the key at once, if
the keyfob serial number is to be entered, or press successively the and
keys, if the serial number is to be read by the ABAX wireless system controller during
transmission.
16. Step 6b. Adding APT-100 keyfob. Depending on the selected method:
– enter the serial number by means of the corresponding number keys (see: ENTERING
DIGITS
) and press the key;
– press any keyfob button – reception of the transmission by the ABAX wireless system
controller will be acknowledged by two short beeps. Press the keyfob key again – two
short beeps will confirm reception of the second transmission by the ABAX wireless
system controller. In the LCD keypad, suitable messages will be displayed to prompt
the user.
Note: For numeration of buttons and LEDs in the APT-100 keyfobs please refer to section
OPERATING THE ALARM SYSTEM BY MEANS OF KEYFOB (p. 45).
17. Step 6c. Assigning function to APT-100 keyfob button 1. Proceed in the same way as
in Step 5c, and then press the key.
18. Step 6d. Assigning function to APT-100 keyfob button 2. Proceed in the same way as
in Step 5c, and then press the key.
19. Step 6e. Assigning function to APT-100 keyfob button 3. Proceed in the same way as
in Step 5c, and then press the key.
20. Step 6f. Assigning function to APT-100 keyfob button 4. Proceed in the same way as
in Step 5c, and then press the key.
21. Step 6g. Assigning function to APT-100 keyfob button 5. Proceed in the same way as
in Step 5c, and then press the key.
22. Step 6h. Assigning function to APT-100 keyfob button 6 (two buttons are pressed
simultaneously: 1 and 5). Proceed in the same way as in Step 5c, and then press the
key.
23. Step 6i. Selecting confirmation for LED 1 in APT-100 keyfob. You can accept the
manner of confirmation provided for by the user schedule, or you can enter a number