SATO s86ex - Hex Dump Mode

4 Operation and Configuration
161
S84-ex/S86-ex Operator Manual
4.2.14 Hex Dump Mode
The hex dump mode allows you to print the contents of the receive buffer in a hexadecimal format to
allow the data stream to be examined for errors and troubleshooting.
The flowchart shows the sequence of the setting screens for the hex dump mode. The table describes
each setting screen in detail.
CAUTION
Be sure to perform a virus check for the USB memory or SD card before connecting it to the printer. SATO
Corporation shall not be held responsible for a malfunction of the printer caused by a virus infection through
the USB memory or SD card.
Hex dump print
RECEIVE BUFFER or
INTERNAL DATA or
SEND BACK DATA
+ button
Shows only when the
PASSWORD input is enabled
Normal print +
Print data save
* Press the , , or button to
select an item or set the value
accordingly. The active arrow icons
are shown on the screen.
Data reception
icon is shown when RECEIVE
DATA is selected.
button
or
button
or
button
button
RECEIVE DATA
+ button
button
button
button
button
Proceed to .
H-A
button
button
PRINT
+ button
button
button
SAVE
+ button
button
Data reception