SATO s86ex - SZPL Emulation Mode

5 Emulation Mode
230
S84-ex/S86-ex Operator Manual
5.2 SZPL Emulation Mode
The SZPL Emulation Mode is available when the printer is loaded with SZPL Emulation firmware. The
RFID option is not supported in this emulation firmware.
The flowchart shows the sequence of the setting screens for the SZPL emulation firmware. The table
describes each setting screen in detail.
* Press the , , or button
to select an item or set the
value accordingly. The active
arrow icons are shown on the
screen.
* Pressing the button on each
screen will revert to the
EMULATION MODE menu.
button
button
(1X), (2X) buttons
21/,1(
47<
(08/$7,2102'(
Shows only when the
PASSWORD input is enabled
button
button
button
527$7(/$%(/
'(*
button
button
6,=(02'(
&0'$872/&'
button
button
/$%(/6,=($'-
:,'7+
button
button
6KLIW
+
button
button
button
button
button
35272&2/
121($&.=(%5$
button
button
561(7:.,'
,'
/$%(/6,=($'-
button
button
+(,*+7
button
button
&21752/+($'(5
&+$5
button
button
button
button
button
Shows only when the LCD is
selected in SIZE MODE.
button
7RS
9
+($'&+(&.
/$%(/
&200$1'+($'(5
&+$5
'(/,0,7(5&+$5
&+$5
(08/$7,2102'(