SATO s86ex - Maintenance of the Print Head and Platen Roller; Maintenance Using the Cleaning Kit

6 Cleaning and Performing Printer Adjustments
242
S84-ex/S86-ex Operator Manual
6.2 Maintenance of the Print Head and Platen
Roller
Maintenance should be performed at the following regular intervals:
• After you print one media roll or print media for one hundred and fifty meters.
Use the cleaning kit to clean these parts:
• Print head • Platen roller
• Media sensors • Media guide
• After you print six media rolls or print media for nine hundred meters.
Use the cleaning sheet to clean these parts:
• Print head • Platen roller
Use the cleaning kit to clean these parts:
• Media guide • Feed roller
• Media route • Ribbon route
Note
The above maintenance intervals are only for reference. Perform the cleaning when necessary.
6.2.1 Maintenance using the Cleaning Kit
The maintenance procedure using the cleaning kit is as follows:
Note
For details on the cleaning kit, refer to the manual attached to the cleaning kit.
1 Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2 Open the top cover.
CAUTION
Open the top cover fully to prevent accidental drop of
the cover.