SATO s86ex - Connecting the Interface Cable; Available Interfaces; Interface Connections

2 Installing the Printer
29
S84-ex/S86-ex Operator Manual
2.5 Connecting the Interface Cable
The connection of the interface cable is explained as follows:
2.5.1 Available Interfaces
This printer supports the following interfaces.
Furthermore, a printer connected with multiple interface cables can continue to operate when receiving
data.
*You cannot receive data from more than one interface at a time.
*You cannot use the USB interface if you have installed the optional wireless LAN.
•USB
•LAN
• RS-232C
• IEEE1284
• Bluetooth
• Wireless LAN (WLAN)
• External signal (EXT)
Note
The wireless LAN interface and Bluetooth interface are optional.
2.5.2 Interface Connections
1 Make sure that the printer, host computer and applicator are powered off.
Set the power switch of the printer to the “O” position.
2 Connect the printer to a host computer with one or more of the available interface
connections.
Use a cable that is compatible with the standard of the interface board as stated in Section 8.13
Interface Specifications. Check the orientation of the connector before you make the connection.
Applicator
Host computer