Scania DC11 - Renewing the Bearing in the Intermediate Gear for the Camshaft

114
©
Scania CV AB 2011, Sweden
01:03-02
Renewing the bearing in the intermediate gear for the camshaft
Special tools
1 Press the shaft out of the bearing.
2 Press the bearing inner race shell from the
shaft and remove the retaining ring.
3 Place the removed bearing inner race in the
bearing and press out the bearing using drift
87 348.
4 Press a new bearing onto the shaft journal
using drift 87 348.
Note: Do not press on the outer race.
5 Press the bearing and shaft journal into the
intermediate gear using drift 87
592.
6 Fit the retaining ring.
7 Press the spacing ring onto the shaft journal.
Ensure that the shaft journal is on the press
table.
Number Denomination Illustration Tool board
87 348 Drift AM1
87 592 Drift -
104 862
87 348
87 592
110 331
01_1361
87 592
Timing gear
www.motodiesel.ir
MASHINESOFT.COM
09120146259