Scania DC11 - Fitting the Camshaft Gear

116
©
Scania CV AB 2011, Sweden
01:03-02
Fitting the camshaft gear
Tightening torques
1 Fit the intermediate gear as described in the
section Fitting the intermediate gear, steps
1-2.
2 Fit the camshaft gear and tighten the bolts to
63 Nm.
3 Fit the flywheel housing according to the
section Fitting the flywheel housing.
4 Fit the flywheel according to the section
Fitting the flywheel.
Bolts for camshaft gears 63 Nm
01 1364
Timing gear
www.motodiesel.ir
MASHINESOFT.COM
09120146259