Scania DC11 - Page 50

50
©
Scania CV AB 2011, Sweden
01:03-02
1 Thread the upper part of the sleeve with
pilot tap 588 221 and guide 99 394.
113 263
99 394
588 221
2 Knock out the pilot tap and sleeve from
underneath. Use a 100 mm metal rod with a
9 mm diameter.
113 284
3 Degrease and check the contact surfaces of
the sleeve and cylinder head. Smooth off
any burrs and irregularities that could score
the sleeve.
4 Degrease the new injector sleeve and apply
a thin film of sealant 561
200 on the sleeve
and cylinder head contact surfaces.
5 Drive in the sleeve using drift 99 381.
IMPORTANT! Ensure that the groove in the
sleeve is located according to the marking.
113 220
Cylinder head
www.motodiesel.ir
MASHINESOFT.COM
09120146259