A.9
Date Code 20170601 Instruction Manual SEL-387-0, -5, -6 Relay
Firmware and Manual Versions
Instruction Manual
Settings Sheets
➤ Added an explanatory note to Combined O/C Elements.
Appendix A
➤ Updated Firmware Revision History and Manual Revision History.
Appendix B
➤ Updated firmware upgrade instructions.
Appendix G
➤ Changed !ALARM to NOTALM in Relay Word Bit row 43 (see Tab le G.7 ).
20050614
Appendix A
➤ Updated Firmware Revision History and Manual Revision History.
Appendix G
➤ Corrected DNP Index references.
20041018
Section 7
➤ Changed number of event summaries in HIS command.
Section 9
➤ Changed number of event summaries in HIS command.
Appendix A
➤ Updated Firmware Revision History and Manual Revision History.
20040628
Section 1
➤ Revised Figure 1.1.
Section 3
➤ Added temperature measurement description.
➤ Added to description of CT Connection (W1CT through W4CT).
➤ Revised definitions for oil thermal time constant description.
Section 4
➤ Revised Table 4.9, Table 4.10, and Table 4.11 to add through-fault information.
Section 5
➤ Resolved grammatical and stylistic issues.
➤ Added temperature measurement description.
Section 6
➤ Modified screen captures depicting default settings for 5 A and 1 A relays.
➤ Added RTD A and RTD B element settings to the Settings Sheets.
Settings Sheets
➤ Resolved stylistic and formatting issues.
Section 7
➤ Added description of the MET T command.
➤ Modified listing of protocol settings available under the SET P command.
➤ Revised Figure 7.2.
Command Summary
➤ Added description of the MET T command to the Command Summary.
Section 8
➤ Modified the description of the PROTO command to include RTDA and RTDB settings.
➤ Added description of dynamic display.
➤ Revised Table 8.3.
➤ Revised Figure 8.5.
Section 10
➤ Added Zero-Sequence Filter Check to the Commissioning Test Worksheet.
Table A.2 Manual Revision History—SEL-387-0, -5, -6 (Sheet 3 of 7)
Revision Date Summary of Revisions
To Next Page