4 Maintenance
4--5
F--9999--8 Build 8 Issue 1
GREASE FITTING
Fig. 4-6. Plastic Feed Slide
4.1.1.4 Plastic Feed Slide
There is one grease fitting located on the plastic
feed slide inside the cover on the plastic feed
mechanism. This fitting should be lubricated
once
every month.
One shot of grease is all that is
necessary.
Note ! Use White Lithium Grease for Plastic
Feed Slide Lubrication.
ASSEMBLY UNIT / VENDOR UNITS INTERVAL LUBE SPECIFICATION
REDUCER (DODGE TIGEAR)
RELIALUBE SYSTEM
-- -- -- -- -- -- -- -- -- -- -- -- MOBIL SHC--634 OR ULTRACHEM
CHEMLUBE 140
(Change oil only when performing
maintenance that requires gearbox
disassembly.)
CHAINS 3 CHAINS 200 HOURS CRC 03050 or Superior Graphite
35201G
FEEDER (3 OUTSIDE, 1 INSIDE) 4 FITTINGS 200 HOURS White Lithium Grease
PLASTIC FEED SLIDE 1 FITTING 200 HOURS White Lithium Grease
Table 4 -1. HAND LUBE LOCATIONS AND INTERVALS Part 1 of 1
To Next Page
Loading...