Sekonic SPECTROMASTER C-800 User Manual

87
5. Measuring Light Sources [Measurement Screen]
3.
Conrm the light measuring range.
When you return to the Measurement screen, make
sure to select Range L ( ).
4.
Press the Measuring Button ❺ .
Measurements are now displayed.
While the button is held, the meter measures
continuously.
When the button is released, the measurements
will stop and the value at the time of release will
be displayed.
NOTE
●
[Over] or [Under] will be displayed if the light source illumination is too bright
or not bright enough, or if the color temperature is out of the measurement
range, when the Measuring Button is pressed.
In this case, adjust the brightness or color temperature of light source.
●
Measurements and display will take longer in light levels below 30lx. The
LCD illumination will normally switch off during measurements to avoid
inuence to measurements.
Measurement in Ambient Light Mode is complete.
C-800
Light Selection Ring
❷
Measuring Button
❺
Range L

Sekonic SPECTROMASTER C-800 Specifications

General

Type	Spectrometer
Color Temperature Range	1, 600 to 40, 000 K
Spectral Wavelength Range	380 to 780 nm
Power Source	Rechargeable lithium-ion battery
Operating Temperature	0 to 40°C (32 to 104°F)
Display	Color LCD
Measurement Range	1 to 200, 000 lx
Spectral Response	Human eye response
Connectivity	USB
Weight	350 g (including battery)
Memory Capacity	Up to 1, 000 measurements