Sensus SensusRF - 16.2 Gwcont Command

75
SensusRF gateway user manual
| 29/10/2019
Returns: ‘ACK’ (if the PIN number provided is correct)
16.2 “Gwcont” command
The “gwcont” command is used for configure GPRS and server parameters. The syntax of the command is:
gwcont,APN,IP,PORT,AUTHENTICATION,USER,PASS
Where:
APN is the carrier Access Point Name (APN)
IP,PORT is the IRIS server IP and PORT the gateway will connect to
AUTHENTICATION is the GPRS Authentication method: 0 (NONE), 1 (CHAP) or 2 (PAP).
USER, PASS is the APN username and password
Returns: ‘ACK’