SensusRF gateway user manual
| 29/10/2019
16.8 “vpn” command
The “vpn” command enabled the VPN client in the gateway. All configuration files must be already loaded
and tested in the gateway, this command will only allow the user to enable the VPN later on.
vpn,[iris_server_ip_or_hostname,iris_server_port]
Where:
Iris_server_ip_or_hostname is the Iris Server the gateway will connect to
Iris_server_port is the IRIS server PORT the gateway will connect to
If the Iris server IP and Port is not provided, the gateway will use its internal configuration to try to
connect to an Iris server.
Once enabled by SMS, the VPN will remain enabled until the gateway reboots.
Returns: ACK – it indicates the SMS command was received. To confirm that the VPN client is connected to
the VPN server, the GVPNIP could be requested, for example.
To Next Page
Loading...
General