SensusRF gateway user manual
| 29/10/2019
16.3 “Ggwcont” command
The “ggwcont” command requests the GPRS & server parameters of configured on the Gateway. The syntax
of the command is:
ggwcont
Returns: GGWCONT,APN,IP,PORT,AUTHENTICATION,USER,PASS
Where:
APN is the carrier Access Point Name (APN)
IP,PORT is the IRIS server IP and PORT the gateway will connect to
AUTHENTICATION is the GPRS Authentication method: 0 (NONE), 1 (CHAP) or 2 (PAP).
USER, PASS is the APN username and password
16.4 “Restart” command
The “restart” command resets the Gateway remotely. The syntax of the command is:
restart
Returns: ACK – it indicates that the restart message was accepted and the Gateway will reboot
To Next Page
Loading...