5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 914
3 UNPACK THE MULTI PURPOSE
1. Remove the Multi Purpose and any other equipment from its packaging.
2. Remove the protective plastic cover from the sample gas inlet on the front of the
Multi Purpose (see Figure 1).
3. Remove the protective plastic cover from the sample gas outlet (on the front or
the rear of the Multi Purpose: see Figures 1 and 2).
4. Remove the protective plastic cover from the bypass gas outlet (if fitted) on the
rear of the Multi Purpose (see Figure 2).
5. Inspect the Multi Purpose and the other items supplied, and check that they are
not damaged. If any item is damaged, immediately contact Servomex or your
local Servomex agent.
6. If you do not intend to use the Multi Purpose immediately:
• Refit the protective plastic covers to the gas inlet, the sample gas outlet and
the bypass gas outlet (if fitted).
• Place the Multi Purpose and any other equipment supplied back in its
protective packaging.
• Store the Multi Purpose as described in Section 9.1.
Otherwise, read Section 4 (User Interface), then continue at Sections 5 onwards
to install, set up, and use the Multi Purpose.
+
Retain the shipping documentation and packaging for future use (for
example, return of the Multi Purpose to Servomex for servicing or repair).
CAUTION
You must remove the protective plastic covers as specified in Steps 3 and 4
above before you use the Multi Purpose. If you do not, you may damage the
Multi Purpose when you try to pass calibration or sample gases through it.
To Next Page
Loading...
Need help?
General
