5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 926
5.2 Charging/recharging the battery (Multi Purpose with optional rechargeable
battery)
5.2.1 Charging
The first time you use a Multi Purpose with the optional rechargeable battery, you
should leave the Multi Purpose connected to the electrical supply for at least 4 hours,
to fully charge the battery.
When the battery is fully charged, you can leave the Multi Purpose connected to the
electrical supply, or you can disconnect the electrical supply and continue to use the
Multi Purpose powered by the battery.
5.2.2 Recharging
During normal use, the battery icon on the status icon bar of the display will identify
the level of charge within the battery (see Section 4.4).
You can recharge the battery as and when required during normal use. To recharge
the battery, simply connect the Multi Purpose to an external electrical supply outlet.
+
We recommend that you recharge the battery as soon as possible after the
‘battery less than 10% full ’ icon is displayed.
+
During recharging, the status icon bar will continually show the ‘battery less
than 10% full’, ‘battery 10 to 32% full’, ‘battery 33 to 65% full’ and ‘battery 66
to 100% full’ icons in sequence.
+
You can recharge the battery with the Multi Purpose switched on or off.
However, recharging will take longer when the Multi Purpose is switched on.
To Next Page
Loading...
Need help?
General
