5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 92
The Multi Purpose is simple to operate, with an intuitive user interface (see Section 4).
Gas sample measurements are shown on the Multi Purpose display, and can also be
output to a serial device connected to the Multi Purpose, or as optional milliAmp
outputs.
The Multi Purpose requires little routine maintenance (see Section 7), other than
calibration (which is essential for the accuracy of sample gas measurements) and
regular inspection of the inlet filter element.
1.4 Sample measurement configurations
The Multi Purpose can be supplied configured to determine one or two gas sample
measurements; the four possible sampling configuration combinations are as follows:
1.5 Other product options
The standard Multi Purpose can be supplied with the following options:
• With an internal sample pump
• With the sample gas outlet on the front or rear of the Multi Purpose
• With a rechargeable battery
• With a printer
• With milliAmp outputs
• With a flowmeter fitted
• With a sample conditioning panel fitted
• With a gas probe accessory
• Protective transport case
The Multi Purpose HF is designed for higher gas flow rates and is supplied with an
internal sample pump fitted.
Measurement 1 gas Measurement 2 gas
1-measurement
Multi Purpose
Oxygen * (not applicable)
IR
†
(not applicable)
2-measurement
Multi Purpose
Oxygen * IR
†
IR
†
IR
†
* Standard, industrial or high-accuracy sensor: see Sections 2.5 to 2.7.
Note that the Multi Purpose HF cannot be supplied with an industrial
oxygen sensor.
† Carbon monoxide or carbon dioxide: see Section 2.8.
To Next Page
Loading...
Need help?
General
