5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 9
33
5.3.5 Selecting pump operation (Multi Purpose HF or standard Multi Purpose
with optional internal sample pump)
If your Multi Purpose has an internal sample pump fitted, you must select how you
want to operate the pump before you start to make sample measurements. The pump
can be operated using one of two methods:
To select the required method of sample pump operation:
1. With the Settings screen displayed, use the and soft keys to highlight
the "Set up" menu option, then press the soft key. The Set up screen will
then be displayed, as shown in Figure 17.
Figure 17 - The Set up screen
2. Use the and soft keys to highlight the "Pump" menu option, then
press the soft key. The Pump mode screen will then be displayed, as
shown in Figure 18 (which shows manual pump operation selected).
Figure 18 - The Pump mode screen
Method Pump operation
Manual When you press the Pump key on the front of the Multi
Purpose (see Figure 1), the sample pump will start. You
must then press the key again, to stop the pump.
Timed When you press the Pump key on the front of the Multi
Purpose (see Figure 1), the sample pump will start,
operate for a preset time, and then stop. If you select this
mode, you must also specify the time for which the pump
should operate.
To Next Page
Loading...
Need help?
General
