5200 Multi Purpose and 5200 Multi Purpose HF Gas Analysers
05230001A / Revision 9
5
2 SPECIFICATION
The SERVOFLEX Mini MP (5200) must be used with a mains supply in order to
comply with TUV/UBA in accordance to QAL1 in EN14181 and EN15267-3.
2.1 General
WARNING
You must install and use the Multi Purpose in accordance with the
requirements of this section and subsequent sections of the manual. If
you do not, the protection facilities incorporated into the design of the
Multi Purpose may not operate as intended, sample gas measurements
may not be accurate, or the Multi Purpose may be damaged.
Dimensions:
height x width x depth 300 x 150 x 260 mm (12 x 6 x 10.5 in.)
Mass (maximum) 2.6 to 3.9 kg (5.7 to 8.6 lb)
Electrical supply requirements
Power supply unit
Multi Purpose
100 to 240 V a.c., 47 to 63 Hz (nominal)
12 to 24 V d.c., 20 W (maximum) *
Minimum gas flow rate
†
Standard Multi Purpose
(with internal sample pump) 700 ml min
-1
(0.025 ft
3
min
-1
)
Multi Purpose HF 1.8 l min
-1
(0.065 ft
3
min
-1
)
* As supplied by the power supply unit (through a centre pin +ve connector).
† Measured at the sample gas inlet, with no accessories fitted to the inlet.
To Next Page
Loading...
Need help?
General
