2
Safety notes for MOVIMOT
®
advanced
Transportation
Operating Instructions – MOVIMOT
®
advanced
12
2.6 Transportation
Inspect the shipment for damage as soon as you receive the delivery. Inform the ship-
ping company immediately about any damage. If the product is damaged, it must not
be assembled, installed or started up.
The lifting eye is designed to carry only the mass of the motor without gear unit.
Tighten the retaining screws of the lifting eye. Mounted gear units have separate sus-
pension attachments, which must be used according to the gear unit operating instruc-
tions when lifting the gearmotor. Do not mount any additional loads.
The following figure depicts the position of the lifting eye of the motor without gear
unit.
9007224557044491
Remove the lifting eye before connecting the PE cable, see chapter "Electrical installa-
tion" > "Installation instructions".
Store the lifting eye for future service work, see chapter "Service" > "Device replace-
ment".
Observe the following notes when transporting the device:
• Always use all attachment points if available. The attachment points are designed
to carry only the mass of the product. Severe or fatal injuries. Do not apply any ad-
ditional loads.
• Ensure that the product is not subject to mechanical impact.
If necessary, use suitable, sufficiently dimensioned handling equipment.
Do not transport or store the product on the fan guard.
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
