8
Service
Extended storage
Operating Instructions – MOVIMOT
®
advanced
206
8.12 Extended storage
8.12.1 Drive
NOTICE
Volatilization of the VCI anti-corrosion agent
Possible damage to property
• Drive units must be kept tightly closed until they are started up.
INFORMATION
For storage periods longer than 9 months, SEW‑EURODRIVE recommends the "Ex-
tended storage" design. Drive units in this design are designated with a correspond-
ing label.
The lubricant of those drive units is then mixed with a VCI anti-corrosion agent (volat-
ile corrosion inhibitors). Please note that this VCI anti-corrosion agent is only effective
in a temperature range of -25°C to +50°C. The shaft ends are also treated with an
anti-corrosion agent. Drive units of the "extended storage" design are equipped with
OS2 surface protection without further notice. Instead of OS2, you can order OS3. For
further information refer to chapter "Surface protection".
8.12.2 Storage conditions
Observe the storage conditions specified in the following table for extended storage:
Climate zone Packaging
1)
Storage location
2)
Storage duration
Temperate
(Europe, USA,
Canada, China
and Russia,
excluding
tropical zones)
Packed in containers,
with desiccant and
moisture indicator
sealed in plastic wrap.
Under roof, protected against rain and
snow, no shock loads.
Up to 3years with regu-
lar checks of the pack-
aging and moisture in-
dicator (relative humid-
ity <50%).
Open Under roof and enclosed at constant
temperature and atmospheric humidity
(5°C<ϑ<50°C, <50% relative hu-
midity).
No sudden temperature fluctuations.
Controlled ventilation with filter (free
from dust and dirt). No aggressive va-
pors, no shocks.
2years or more with
regular inspections.
Check for cleanness
and mechanical dam-
age during the inspec-
tion. Check corrosion
protection.
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
