EasyManuals Logo

SEW-Eurodrive MOVIMOT advanced DRN DBC Series User Manual

SEW-Eurodrive MOVIMOT advanced DRN DBC Series
312 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #139 background imageLoading...
Page #139 background image
8
Service
Description of status and operating displays
Operating Instructions – MOVIMOT
®
advanced
139
8.6 Description of status and operating displays
8.6.1 LED displays of the binary control
The following figure shows the LEDs of the binary design:
DBC10A-0020-503-A-000-000
Binary
DRIVE
[1]
18014427523368971
[1] "DRIVE" status LED
8.6.2 General LEDs
"DRIVE" status LED
LED Operating status/ Meaning Measure
Fault
code
Subfault code
Off
Not ready for operation Line voltage absent. Switch on the line
voltage.
Yellow
Flashes very rap-
idly, 4Hz
Not ready for operation Initialization phase Wait for the initializa-
tion to be completed.
Yellow
Flashes 1Hz
Ready but unit inhibited The "STO" signal is active. Deactivate the
"STO” signal.
Yellow
Flashes slowly,
0.5Hz
Ready for operation, but
manual mode/local mode,
device inhibited
Line voltage is OK.
Yellow
Flashes rapidly,
2Hz
Ready Deactivation of DynaStop
®
without drive enable is active.
Yellow
Steady light
Ready but unit inhibited Line voltage is OK.
The output stage is locked.
25891936/EN – 05/2020

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SEW-Eurodrive MOVIMOT advanced DRN DBC Series and is the answer not in the manual?

SEW-Eurodrive MOVIMOT advanced DRN DBC Series Specifications

General IconGeneral
BrandSEW-Eurodrive
ModelMOVIMOT advanced DRN DBC Series
CategoryDC Drives
LanguageEnglish

Related product manuals