8
Service
Fault messages with parameterizable response
Operating Instructions – MOVIMOT
®
advanced
137
Fault Description Index
no.
Possible fault response
External synchronization Here you can set the device re-
sponse to loss of external synchro-
nization.
8622.7
• No response
• Warning
• Application stop (with out-
put stage inhibit)
• Emergency stop (with out-
put stage inhibit)
• Inhibit output stage
• Warning with self-reset
• Application stop (with out-
put stage inhibit) with self-
reset
• Emergency stop (with out-
put stage inhibit) with self-
reset
• Inhibit output stage with self
reset
Motor temperature pre-
warning – current param-
eter set
Motor temperature current parame-
ter set – prewarning.
8442.5
• No response
• Warning
• Application stop (with out-
put stage inhibit)
• Emergency stop (with out-
put stage inhibit)
• Inhibit output stage
Electromechanical capa-
city utilization – prewarn-
ing
Here you can set the device re-
sponse to an exceeded prewarning
threshold for electromechanical ca-
pacity utilization (index 8336.2).
8622.10
• No response
• Warning
• Application stop (with out-
put stage inhibit)
• Emergency stop (with out-
put stage inhibit)
• Inhibit output stage
HW limit switches – cur-
rent parameter set
8572.1
• No response
• Emergency stop (with out-
put stage inhibit)
• Emergency stop (with out-
put stage inhibit) with self-
reset
SW limit switches – cur-
rent parameter set
8572.2
• No response
• Emergency stop (with out-
put stage inhibit)
• Emergency stop (with out-
put stage inhibit) with self-
reset
25891936/EN – 05/2020
To Next Page
Loading...
Need help?
General
