SEW DRC2 - Inspection and Maintenance; Determining the Operating Hours

156
Operating Instructions – Electronic Motor DRC.-..-SNI
11
Determining the operating hours
Inspection and Maintenance
11 Inspection and Maintenance
11.1 Determining the operating hours
11.1.1 About MOVITOOLS
®
MotionStudio
To facilitate inspection and maintenance planning, you can read out the performed
operating hours of DRC drive units. Proceed as follows to determine the performed
hours of operation:
1. In MOVITOOLS
®
MotionStudio, open the DRC parameter tree. See chapter "Config-
uration and diagnostics".
2. In the parameter tree, select the node "DRC power section parameters / display
values / unit status" [1].
3. In the statistics data group [2], you can read out the performed hours of operation:
9007201614909195
[1] Power section parameters / display values / unit status
[2] Statistics data group
[1]
[2]