Operating Instructions – Electronic Motor DRC.-..-SNI
9
2
Designated use
Safety Notes
2.3 Designated use
DRC drive units are components intended for installation in electrical systems or ma-
chines.
In case of installation in machines, taking the DRC drive units into operation (i.e. start of
designated operation) is prohibited until it is determined that the machine meets the re-
quirements stipulated in EC Directive 2006/42/EC (Machinery Directive).
Startup (i.e. the start of designated use) is only permitted under observance of EMC
directive 2004/108/EC (EMC Directive).
DRC drive units comply with the regulations of the Low Voltage Directive 2006/95/EC.
The standards given in the declaration of conformity are applied to the DRC drive units.
You must observe the technical data and information on the connection requirements
as provided on the nameplate and in the documentation.
2.3.1 Safety functions
DRC drive units may not
perform safety functions unless these functions are described
and expressly permitted.
2.3.2 Lifting applications
DRC drive units are not designed for use as safety devices in lifting applications.
2.4 Other applicable documentation
Note also the following documentation:
• "DRC Gearmotors" catalog
• Operating instructions for the gear unit (only for DRC gearmotors)
You can download or order these publications on the Internet (http://www.sew-
eurodrive.com under the heading "Documentation").
2.5 Transportation, storage
You must observe the notes on transportation, storage and proper handling. Comply
with the requirements for climatic conditions stated in chapter "Technical Data". Tighten
installed eyebolts securely. They are designed for the weight of the DRC drive unit. Do
not attach any additional loads. Use suitable, sufficiently rated handling equipment (e.g.
rope guides) if required.
To Next Page
Loading...