Operating Instructions – Electronic Motor DRC.-..-SNI
27
4
Setting up the drive unit
Mechanical Installation
Min. installation
clearance of
application options
Note the minimum installation clearance (see following figure) required to install and
remove the application options.
4.4.3 Installation in damp locations or in the open
Drives are supplied in corrosion-resistant versions for use in damp areas or in the open.
Repair any damage to the paint work if necessary.
Observe the notes in chapter "Drive units with optional ASEPTIC / ASEPTIC
plus
design".
4.4.4 Painting drive units
9007201604871563
200
NOTICE
Breather valves and oil seals may be damaged during painting or re-painting.
Potential damage to property.
• Clean the surface of the drive unit and make sure it is free from grease.
• Thoroughly cover the breather valves and sealing lip of the oil seals with strips prior
to painting.
• Remove the strips after painting.
To Next Page
Loading...
