26
EZ Set Up (With Auto Clock Setting)
Important! (Caution during EZ Set Up):
• Do not press the POWER button on the Unit or remote control.
• Do not insert a video cassette into the Unit.
The EZ Set Up function automatically sets the tuner channels and clock when the antenna cable is connected
to the rear of the Unit and the power plug is then connected to an AC outlet.
Important!
When using a cable box:
• See Cable TV Connections on page 20.
• Leave POWER on the cable box turned on and select a channel that carries EDS signals.
1 Make sure that the antenna cable is connected. For connection configuration, refer to Connecting a TV on
page 17.
2 Connect the Unit’s power plug to an AC outlet.
3 The tuner channels and clock will automatically be set.
• This Unit can monitor and use time-signals (EDS signals), which are provided by some TV stations, to
automatically adjust the VCR clock. This Unit automatically searches EDS signals, but if you are in a
hurry to use timer recording or know the channel of the EDS signal carrier in your area, follow the
procedure in Auto Clock Setting or Manual Clock Setting.
During Auto Channel Setting During Auto Clock Setting EZ Set Up complete
• If power is supplied to the Unit before the cable is connected, EZ Set Up will not be able to preset the channels into
memory. If this occurs, unplug the Unit from the power source and wait a few minutes. Check the cable /antenna
connection and supply power to the Unit. EZ Set Up will automatically begin again.
• If the power is turned on during EZ Set Up, the Auto Channel setting will be interrupted and the tuner channels will not
be able to be preset.
• Auto Clock Setting may take several minutes.
• If the Auto Clock Setting is not completed within 30 minutes, there may be no channels with EDS signals. In this case,
set the clock manually. (See Manual Clock Setting on page 35.)
• If the antenna signal is weak, the Auto Clock Setting function may not operate.
• During initial channel setting, the channels are set into the AIR channel setting. To watch a cable TV channel, select
“CATV” on the CHANNEL PRESET screen. (See Channel Setting on page 32.)
PLAYREW PLAY STOP
VCR / DVD COMBINATION
OPEN/
CLOSE
VCR DVD
(AV 1 )
EJECT/STOPPOWER
STANDBY
CH(TRACKING)
L(MONO)-AUDIO-RAV 2 IN VDEO
POWER
To Next Page
Loading...
