73
Tape Dubbing
Tape Dubbing Connection Instructions
Your Unit can dub (copy) video material from another video device. It
can also output video and audio signals for recording on other video
or audio equipment. Audio/Video dubbing cannot be done sepa-
rately.
1 Switch your Unit to the auxiliary input by pressing INPUT. “AV 1”
lights up on the VCR Front Panel display. (You can also use
CH ' / ".)
2 Begin recording on the dubbing VCR and playback on the
source VCR simultaneously.
• When using special playback functions (still picture, video search,
frame advance, and variable slow motion) during dubbing, a blue
screen may appear.
Set BLUE SCREEN mode on the dubbing VCR (for recording) to OFF.
(See Mode Selection on page 31.)
• To use the TV as a monitor while dubbing, press TV/VCR to “VCR” on
the dubbing VCR.
• Use an RCA pin–type connection cable (not supplied with VCR, but
supplied with VIEWCAM) to connect source VCR to dubbing VCR.
• Refer to the manual of the VCR connected to this unit when dubbing a
tape.
• You can also use the front AV jacks. Select “AV 2” (Aux. 2 input) by
pressing INPUT twice.
• If source VCR is a monaural mode, connect the audio cable to
“AUDIO-L” of the dubbing VCR.
To Next Page
Loading...
