Sharp DV-NC55U

34
100
OPEN/
CLOSE
VCR/DVD
SELECTOR
VCR MENU
DVD SETUP
TAPE
SPEED
ON
SCREEN
TIMER
ON/OFF
TITLE
DVD MENU
DISPLAY
TV/VCR EJECT
FUNCTION
CONTROL
PROGRAM ZOOM
CANCEL
RETURN
REV FWD
SET
ENTER
ZERO BACK
SKIP SEARCH
REPLAY
VCR DVDAM/PM INPUT
PAUSE/STILL
REC
VCR/DVD COMBINATION
PLAY
STOP
SLOW
CH
VCR DVD
SKIP
DPSS
AUDIO
OUTPUT
POWER
VCR MENU
SET
POWER
Clock Setting
Auto Clock Setting
(If you DO know a channel that carries EDS signals)
Preparation
• See Watching VCR on page 27.
Important!
When using a cable box:
• See Cable TV Connections on page 20.
• Leave POWER on the cable box turned on and select a channel
that carries EDS signals.
1 Press VCR MENU. Select “CLOCK” with ' / " and then press
SET.
SET UP
MENU
ENTER :SET EXIT :MENU
CHANNEL PRESET
SELECT :
CLOCK
LANGUAGE
TIMER
2 Select “AUTO” with ' / " and then press SET.
MANUAL
CLOCK
AUTO
3 Set EDS CH SET mode to “MANUAL” with
\\
\\
\ /
||
||
| and then press
".
EDS CH SET AUTO MANUAL
EDS CH 02
AL
4 Select a channel that carries EDS signals with
\\
\\
\ /
||
||
|.
(Example) 07
• The number of channels that can be selected depends on the
mode setting on the CHANNEL PRESET screen.
See NOTE.
When using a cable box:
Input the output channel (02, 03, or 04) of the cable box.
EDS CH SET AUTO MANUAL
EDS CH 07
5 Press SET to enter. The screen returns to normal.
6 Press POWER to turn off the Unit.
• The Auto Clock Setting function will automatically set the
clock.
• If the EDS CH SET mode is set to
MANUAL mode in Step 3 and a channel
that does not carry EDS signal is
selected in Step 4, the Auto Clock
Setting function will not operate.
• In Step 4, the number of channels that
can be selected depends on the mode
setting on the CHANNEL PRESET
screen. See the table below.
• In Step 1, if you press VCR MENU when
operating the screen setting for the first
time or after a power failure of more than
60 seconds, the LANGUAGE screen will
appear.
• If you entered incorrect data during the
setting procedure, re-enter the correct
data in the following manner:
1 Use
\\
\\
\ /
||
||
| to select the data to be
corrected.
2 Set the correct data with ' / ".
3 After correcting the data in Step 2,
press SET to enter.
• If you press VCR MENU in Step 5, the
data will not be stored.
• If a button is not pressed within 3 minutes
during the setting procedure, the screen will
return to the normal screen.
AIR/CATV Channels to be selected
AIR
CATV
02 03 04 68 69 02
01 02 03 124 125 01
VCR Setup