Sharp VL-DC1E - Frame Advance; Strobe Playback; Turning off the LCD Monitor Backlight

Basic Operations
Playback
Frame Advance
During still picture playback, press the
F.ADV/STROBE button on the remote
control. Each time you press the button,
the picture advances one frame.
To return to normal playback, press the
PLAY button ( F).
PLAY buttor
1 PAUSE/STILL button
F.ADV/STROBE button
Strobe Playback
During normal playback, press the
F.ADV/STROBE button on the remote
control. The VIEWCAM plays back one
frame at a time at approximately l/4 set
intervals.
To return to normal playback, press the
PLAY button ( F).
- PLAY button
L- F.ADV/STROBE button
Turning Off the LCD Monitor
Backlight
This VIEWCAM’s LCD monitor uses a fluores-
cent lamp for backlighting (see page 62).
order to reduce battery consumption. you
turn off the lamp when backlighting is not
necessary (e.g. when you are watching a
playback on a connected TV’s screen).
While the VIEWCAM is in Camera or VCR
In
can
mode. hold down the MODE DISPLAY button
for more than 5 seconds. The backlight will turn
off and the LAMP OFF indicator will light up.
To turn it on again, press the MODE DISPLAY
button. or set the Power switch to OFF and then
back to CAMERA or VCR.
MODE DISPLAY button
1.
;,
‘,
LAMP OFF j
‘?.
‘,
‘...
indicator /..f
Notes:
l The LAMP OFF indicator will blink when the
monitor is off to indicate that there is a warning
message. Press the MODE DISPLAY button and
check the message on the monitor.
l Turning the LCD monitor on and off repeatedly
may deplete battery power.
Note:
l Frame advance and strobe playback functions
cannot be controlled from the VIEWCAM.