63
8012707/ZVF9/V2-1/2019-04 | SICK OPERATING INSTRUCTIONS | GM32
Subject to change without notice
SHUTDOWN 8
4 For GPP probe: Switch off the power supply of the heater.
5 For GMP probe: Switch the purge air supply off and disconnect the purge air hose on the
device flange.
6 Close off the flange on the gas duct with a cover.
8.2 Storage
1 Clean the exterior of all housings, the measuring probe and all further components
including the purge air unit (when fitted)) with damp cleaning cloths. A mild cleaning
agent can be used.
2 Check the desiccant cartridges and replace, if required, see “Checking and replacing the
desiccant cartridges”, page 50).
3 Protect the openings of the SR-unit and the reflector unit from atmospheric influences
(preferably with the transport safety devices, according to see “Transport safety
devices”, page 29.
4 Pack the GM32 for storage or transport (preferably in the original packing).
5 Store the GM32 in a dry, clean room.
8.3 Environmentally compatible disposal/recycling
The GM32 can be disposed off as industrial waste.
The following subassemblies could contain substances that have to be disposed of
separately:
● Electronics: Capacitors, rechargeable batteries, batteries.
● Display: Liquid of LC display.
● Probes: Probes can be contaminated with pollutants.
▸ Observe relevant local conditions for disposal of industrial waste.
To Next Page
Loading...
Need help?
General
