Table of contents
User Instructions
IDM corded
4
© SICK AG · Germany · All rights reserved · Subject to change without notice 8015906/2013-07-02
2.5.3 Delay Settings .................................................................................................................... 46
2.5.4 Emula
tion Settings, Key Pad Emulation, Upper/Lower Case Settings ........................... 47
2.6 Serial Interface Control
................................................................................................................... 48
2.6.1 Record Suffix, Preamble, Posta
mble Settings ................................................................. 48
2.6.2 Delay Settings
.................................................................................................................... 49
2.6.3 Protocol, ACK/ NAK Settings
............................................................................................. 50
2.6.4 Response Time-out, Baud Rate Settings
.......................................................................... 51
2.6.5 Data Frame Settings
.......................................................................................................... 52
2.7 Wand/ Laser Emulation Control (IDM1xx series)
.......................................................................... 53
2.7.1 Outp
ut Polarity, Signal State, Margin/ Module Time ....................................................... 53
2.8 Opera
tion Control (IDM1xx series)................................................................................................. 54
2.8.1 Opera
tion Mode Setting..................................................................................................... 54
2.8.2 Presentation Control, Sca
n Rate, Flash Duty ................................................................... 56
2.8.3 1D Barcode
Reading Direction.......................................................................................... 57
2.9 Opera
tion Control (IDM2xx series)................................................................................................. 58
2.9.1 Opera
tion, Presentation and Illumination Control ...........................................................58
2.9.2 Aiming Control, Delay Aiming, Decode
Aiming Control .................................................... 59
2.9.3 Center Alignment, Unique Barcode Reporting
................................................................. 60
2.9.4 Batch Reading
.................................................................................................................... 61
2.10 Opera
tion Control (all IDM series).................................................................................................. 64
2.10.1 Buzzer, Indicator, Vibrator Control
.................................................................................. 64
2.10.2 Dollar Sign, Redundancy,
1D Code Inverse Reading .................................................... 65
2.10.3 Reread Dela
y, Good Read Delay Control........................................................................ 66
2.10.4 Light Source
On Time, Hands Free Time-out ................................................................. 67
2.10.5 Presentation Auto-Sense ,
Sensitivity............................................................................. 68
2.11 Condensed Data Wiza
rd.................................................................................................................69
2.11.1 Prea
mble, Postamble, Data Length, Symbol ID Transmission .....................................69
2.11.2 Data Formatter Settings
.................................................................................................. 70
2.11.3 Data Verifier Settings
...................................................................................................... 71
2.11.4 Data Replacer Settings
................................................................................................... 72
2.11.5 Data Organizer Settings
.................................................................................................. 73
2.11.6 Select a Barcode Symbology
........................................................................................... 74
2.11.7 Position Calculation
......................................................................................................... 75
2.11.8 Application Example
........................................................................................................ 75
3 Appendix
............................................................................................................................................................. 77
3.1 Symbology I
D Table (1D Codes)..................................................................................................... 77
3.2 Symbology I
D table (2D and Post codes) ...................................................................................... 78
3.3 Keyboa
rd Function Code Table ...................................................................................................... 78
3.4 ASCII Input Shortcut (Reference Table)
......................................................................................... 79
3.5 Host Interface Quick Set
................................................................................................................. 80
3.6 Opera
tion Mode Quick Set (IDM1xx series) .................................................................................. 81
3.7 Opera
tion Mode Quick Set (IDM2xx series) .................................................................................. 82
3.8 Option Codes
................................................................................................................................... 83
3.9 System Commands
......................................................................................................................... 84
To Next Page
Loading...
Need help?
General
