Condensed Data Wizard
User Instructions
IDM corded
72
© SICK AG · Germany · All rights reserved · Subject to change without notice 8015906/2013-07-02
2.11.4 Data Replacer Settings
The Data Replacer is used to edit the scanned raw data prior to transmitting the data to the host computers
or terminals. It allows you to select desired barcode symbologies for replacer control, and provides Multiple
Position Replacement in the identified position.
All data must conform to the Identified Bar Code Symbologies, and one to three Identified Characters in the
identified position. While the Data Replacer is enabled, it arranges only scanned data without Preamble,
Postamble, STX, ETX, Data Length, Prefix/Suffix Symbology ID or Record Suffix.
Regarding the “Bar Code Selection” and “Position Calculation” of Data Replacer, please refer to page 74 and
75 for details. All “Character” input should be referred to th
e ASCII/HEX Table listed in the Appendix (page 79)
to find matched HEX value.
PROGRAM F_DEFAULT
Family Code Selection P.C. Parameter Selection Option Code 2nd Option Code
SS Disable FIN
MS
Select one barcode symbology (2 digits)
Automatic termination
Replacer Control
MS
Select all barcode symbologies 00
Automatic termination
SS Disable FIN
DS
Enable Position: (2 digits) [00-7F]
1st Replacement
2-digits identified position; 1
replacement character
SS Disable FIN
DS
Enable Position: (2 digits) [00-7F]
2nd Replacement
2-digits identified position; 1
replacement character
SS Disable FIN
DS
Enable Position: (2 digits) [00-7F]
3rd Replacement
2-digits identified position; 1
replacement character
To Next Page
Loading...
Need help?
General
