User Instructions
Serial Interface Control
IDM corded
8015906/2013-07-02 © SICK AG · Germany · All rights reserved · Subject to change without notice
49
2.6.2 Delay Settings
PROGRAM F_DEFAULT
Family Code Selection P.C. Parameter Selection Option Code
SS None FIN
MS 1-99 (x5) msec. (2 digits)
Intermessage Delay
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
SS None FIN
MS 1-99 (x5) msec. (2 digits)
Intercharacter Delay
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
SS None FIN
MS 1-99 (x5) msec. (2 digits)
Interfunction Delay
Scan 2 digits from the option code chart in the Appendix;
then the scanner will terminate this selection automatically.
Intermessage Delay: is a time delay between messages outputted by the Hand-held scanner. Increasing this
delay will help host applications to process the incoming data on time.
Intercharacter Delay: is a time delay between data characters outputted by the Hand-held scanner. These two
parameters are used to synchronize data communication when: 1) the data transmission speed is too fast,
characters may be skipped; 2) multitasking operation system or host computers in a network may slow down
the keyboard handling; 3) various notebook or desktop PC systems require different timing parameter
settings. It is recommended to always add one extra unit as safety margin when adjusting these two
parameters.
Interfunction Delay: is a time delay of between transmission and reception of each segment of the message
string.
To Next Page
Loading...
Need help?
General
