EasyManuals Logo

SICK IDM series User Instructions

SICK IDM series
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #84 background imageLoading...
Page #84 background image
System Commands
User Instructions
IDM corded
84
© SICK AG · Germany · All rights reserved · Subject to change without notice 8015906/2013-07-02
3.9 System Commands
PROGRAM
System Information List
(Enter Programming Mode)
(SYSLIST)
Safe User Default
FIN (Finish)
IDM Set Up Link
User Default
END
Master Default
(Exit Programming Mode)
Factory Default
Factory Default: After scanning “Factory Default” command, all parameters will be returned to factory default
value.
Master Default: After scanning “Master Default” command, the scanner will remain the pre-set parameters of
Host Interface Selection, Keyboard Interface Control (except Record Suffix; Preamble; Postamble), Serial
Interface Control (except Record Suffix; Preamble; Postamble), and Wand/Laser Emulation Control, the rest of
the parameters will be returned to default value.
User Default: After scanning “Save User Default” command, all current parameters will be stored to the flash
memory. Once you change the parameter and would like to return to previous setting, please scan “User
Default”.

Table of Contents

Other manuals for SICK IDM series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SICK IDM series and is the answer not in the manual?

SICK IDM series Specifications

General IconGeneral
BrandSICK
ModelIDM series
CategoryBarcode Reader
LanguageEnglish

Related product manuals